Thursday, December 17, 2015

Get The Right Amount of Concrete Before You Pour!

Get The Right Amount of Concrete Before You Pour!Putting in new concrete is one job that can become very messy if done incorrectly. That’s why it is so important to have the right amount of concrete to complete the job. Here are a few tips to make sure you don’t end up with too much – or too little – to get your project done.

All About Dimensions

Say you are putting down new concrete for your driveway. When trying to figure out how much concrete you will need, take into account the width, length and thickness of the driveway you’re planning to pour. Once you have those, there is a concrete calculator on our home page that you can use to determine the number of cubic yards that will be needed for your project.

The Thicker, The Better

When measuring the thickness of your concrete, be sure to add a quarter-inch to the total number. This additional volume can help accommodate up for areas where the grade you’re pouring over is uneven. This is important because if you are paving a new patio or sidewalk, you don’t want it to be uneven or below the grade of your existing yard.

Allow a Margin for Error

In addition to embellishing the thickness, allow yourself some room for error with the amount of concrete you need. Depending on how many total yards of concrete you need, you should order anywhere from half a yard to one and a half yards more.

Keep It Simple

If the area you are looking to pour the cement into is an irregular shape then do this: break it down into smaller, simpler shapes. That way you can make more precise measurements of the easily defined portions, allowing you to more accurately determine how much concrete you will need.

Bergen Mobile Concrete provides concrete pouring and installation in New Jersey using the latest technology. For more information on our services, give us a call today at 201-797-7550!


The post Get The Right Amount of Concrete Before You Pour! was originally seen from http://www.bergenmobileconcrete.com

No comments:

Post a Comment